Tina2Plus Unboxing Guide

Remove the 3D printer and accessories from the packaging box.

 

① Check the seal to ensure that you receive a new machine.


② Open the package and remove all accessories and the machine.


Remove all fixtures inside the 3D printer then insert the filament guide tube.

① Remove the foam.


② Tear off the tapes.



③ According to the label to remove the shaft coupling shell .



 

④ Take out the tube, press the tube fitting, and insert it into the extruder until it is about 2 cm deep.



 

Insert the TF card into the 3D printer, plug in the power adapter, and turn on the power

 

① Insert the TF card, pay attention to the direction. Incorrect insertion may damage the card.



 

② Plug in the power cord.


③ Turn on the power switch.


insert the filament into the 3D printer and perform the loading operation.

① Take out the filament.Cut a diagonal slit to prevent it from getting jammed.


 

② Insert the filament into the nozzle,making sure to insert it all the way.



 

③ Selecting the language.


 

④ Click  "Load Filament"and wait for the nozzle to heat up to 210°C.



 

⑤ Wait for the filament come out of the nozzle.


 

Frequently Asked Questions:

1.        Q: What should I do if the seal is damaged?
 A: Please contact online support in the app, and our customer service will assist you with after-sales support.

2.        Q: What should I do if any accessories are missing?
 A: Please contact online support in the app, and our customer service will send you the missing accessories.

3.       Q: Can I use third-party accessories with this product?
A: We recommend using only manufacturer-approved accessories to ensure optimal performance and avoid damage.

4.        Q: What happens if the tube is not inserted all the way?
 A: The filament may get stuck in the tube when inserting it into the extruder.

5.       Q: What happens if the TF card is inserted incorrectly?
 A: The TF card may be damaged. Whether inserting the TF card into a 3D printer or into a USB drive before connecting or disconnecting from a computer, careful handling is necessary.

6.      Q: What should I do if the filament is not coming out?
A: Check if the filament is jammed in the extruder or stuck in the tube. Please reinsert the filament and ensure it is properly fed into the nozzle.